Atomlab 100 Plus Dose Calibrator

The Atomlab 100 Plus Dose Calibrator performs all standard dose calibrations and then some. The Atomlab 100 Plus provides fast, accurate radionuclide activity measurements with performance that easily surpasses the most stringent regulatory requirements.

All functions microprocessor controlled
Ultra-fast response
Automatic range selection Ranges up to 9.999 Curies
Tc-99m or 2.5 Curies of F-18
Pre-programmed for the most commonly used radionuclides
Display in Curies or Becquerels
Automatic background subtraction and zeroing at the touch of a button
Remote ionization chamber with .25" (.64 cm) lead shielding and 10-foot (3.05 m) cable
Self-diagnostic software
Daily constancy isotope keys
Electronic power supply (no battery in chamber)
Industry exclusive two-year warranty
Clock/Calendar
Print “peel and stick” syringe/vial labels and patient labels
Constancy reports with carbonless copies for Co-57, Cs-137, and Ba-133
Save up to two months of constancy data
RS-232 bi-directional serial communications port
Dot matrix printer (with tractor feed)
ETL to UL 3101-1 and cETL to CAN/CSA C22.2 No. 1010.1-M92

The Atomlab 100 Plus Dose Calibrator is simple to operate. There are 13 isotope selection keys, 12 are pre-programmed for the most commonly used radionuclides and 1 is user defined. There are 88 isotope-specific dial values listed in the manual, including Y-90 and Sr-89. Any key can be reprogrammed by the user for a desired isotope.

Activity is displayed on a LED readout in either Curie or Becquerel units. Background correction and zero adjustment are performed at the touch of a button. Range selection is automatic.

Activity measurements are performed by a microprocessor controlled electrometer of the Atomlab 100 Plus Dose Calibrator located within the detector assembly of the ionization chamber. The chamber is shielded with .25" (.64 cm) lead. It can be located up to ten feet away from the display unit. Chamber bias is generated within the display unit by an electronic high voltage supply, eliminating the need for expensive battery changes.

Atomlab 100Plus Dose Calibrator

Print Labels and Constancy Reports
The Atomlab 100 Plus will generate peel and stick labels. Each label shows the selected isotope, activity, date and time. At the time the label is printed, a carbonless copy is also produced for department record keeping.

The Power-Up/Self-Test Report is automatically printed. Constancy Reports for Co-57, Cs-137 and Ba-133 may be selected for the current or previous month. Constancy Reports are easy to read and feature three caution warnings: measurement error that exceeds ±5% of the decayed standard, error that exceeds 10% of the decayed standard and decayed standard less than 50µCi.

The RS-232 Port enables the Atomlab 100 Plus Dose Calibrator to communicate with most commercially available nuclear medicine management systems.

Clock/Calendar
Enter time and date in setup mode with a few simple keystrokes, and the Atomlab 100 Plus will continually update this information and automatically print it on all reports.

086-265 Atomlab 100 Plus Dose Calibrator $6,300.00

086-268 Labels, “Peel & Stick”, 200/roll $42.00
086-278 Printer Ribbon, 4/pkg $18.00